| JM-115C Compressor View Specs | |
|---|---|
 |
"I love it! Very sonically invisible for a compressor as far as the freq response... As far as the compressor part, very natural and musical... I would say it's like a DBX160 that is modern and hifi and very quiet. I know it's not easy to do a one knob compressor (aka, no attack/release) and please people, but I can say yours does!" Peter Moshay |
The JM-115C is a Transformer coupled In/Out VCA based compressor using true RMS detecting similar to the DBX 160VU. Ratio starts at a very low setting 1:2 for a very small amount of compression. Like the 160VU the JM-115C is very easy to set up, simply start at a low ratio, set the threshold around +4 to +10dB and output where needed to get the level to tape you need.! The JM-115C has a very short and direct signal path allowing for very low distortion and very low noise, it’s a very clean transparent compressor. It does not pad the input (reduce level) before compression, allowing maximum dynamic range from your mic pres ect. Available in either the 500 Series module or the stand alone that will run off the same supply as the JM-130 mic pre.. Each JM-115C is hand wired and tested. |
|
|
|
||